Pushing new fast 3 mw boiler manufacturer - a low nitrogen vacuum boiler "APH the T7" heavy starting at the show, numerous suction eye. "Thalia T7" launch, breaking the old burners + furnace construction mode, rational arrangement of low nitrogen burners, coupled with the furnace scientific, greatly enhance the operational efficiency of the boiler, the real "coupled," "burning "Tiancheng.
3, coal combustion 3 mw boiler manufacturer technology
This technique is performed by coal-fired boilers, pulverized coal amount to be injected into the furnace in place, so that the combustion grate base layer, an appropriate amount of the suspension increases combustion energy can be obtained a certain rate. As for boiler fuel, gas type, you can replace the old with the new energy-saving burner, behind the burner to be transformed.
Gas fired 3 mw boiler manufacturers into boilers which benefit: the traditional coal-fired steam boiler in the use of the process releases large amounts of carbon dioxide, sulfur dioxide and other harmful gases, causing serious air pollution and acid rain, and coal are non-renewable resources, Earth the storage capacity is limited, and the price of coal is relatively high with the successive implementation of the national policy of reform coal, coal-fired boiler traditional high pollution and high consumption market gradually been criticized, many provinces and cities have started from coal to gas work, namely the traditional coal-fired boilers to become clean non-polluting gas boilers, and strive to achieve the unity of economic and social benefits. In conventional coal-fired boilers used in the process releases large amounts of carbon dioxide, sulfur dioxide and other harmful gases, causing serious air pollution, and acid rain, while the coal are non-renewable resources, the limited storage capacity on the earth, and the price of coal is relatively higher, therefore, imperative coal to gas has the advantage.
Operation of the gas 3 mw boiler manufacturer has what measures? Gas-fired boiler in many large factories or companies which, basically is a kind of device can see, of course, such a device is actually in the process of actually running, more or less have some of their own operating standards, from the current situation, when they run have more to do security measures. So what are run gas boiler measures at run time? (1) After a series of gas-fired boiler inspection, maintenance, basically in the process of running to them in accordance with the relevant requirements to run, there will have a lot of protection, even if they want to determine the importance of the protection of the entire work. (2) gas-fired boiler in the process of ignition, more or less likely to occur will require some regulations, such as they might meet some of the fuel, but the fuel pressure in the whole process of evaporation or mist, more or less will meet some of stroke, some extent, when the entire examination will also return to substantially a normal state, they energize the disable signal is short, when the flow rate of the whole is greater than a single second branched oil gun 0.65 kg when it should launch this gun running. (3) gas-fired boiler at the time of ignition, be sure to pay attention to look at all of the furnace temperature, the temperature inside look at the major, and the entire main steam pressure in the process of rising more or less there will be some obvious favoritism, or the case of speech do not rise, so then we should immediately go to the examination of fire tank. in addition, if found throughout the fuel into the furnace did not catch fire, it would tightly shutdown.
